Forgive me, I am a network engineer. I am trying to setup an HA pair of FAS6280s running 8.1.4 7-Mode. I have installed QLogic CNAs (1140-R6) and they have been recognized by the FAS. However, I cannot get the link to come up (see below):
Slot: 3b Description: Fibre Channel Target Adapter 3b (QLogic CNA 8112 (8152) rev. 2)
Status: LINK NOT CONNECTED
Host Port Address: 0x000000
Firmware Rev: 5.5.2 MPI
Firmware Rev: 1.40.5 PHY
Firmware Rev: 1.8.0
FC VLAN ID: 0
FC Nodename: 50:0a:09:80:8f:b0:d1:c8 (500a09808fb0d1c8)
FC Portname: 50:0a:09:88:9f:b0:d1:c8 (500a09889fb0d1c8)
FC Packet Size: 2048
Data Link Rate: 0 GBit
Adapter Type: Local
Fabric Established: No
Connection Established: Loop
Mediatype: ptp
Partner Adapter: None
Standby: No
Target Port ID: 0x106
Switch Port: Unknown
Physical Link Rate: 10 GBit
Physical Link Status: LINK UP
Anybody be able to help me out?