Hello All,
Quick question. I have a FAS8200 series storage array that is in the process of being setup without professional services. I have configured ports e0a and e0b on both controlletrs and they are up, as you can see below.
Now when I connect the 40Gbe breakoput cable to my Cisco switch, I get no activity and only an orange light on the switch.
The ports on the array are green but no activity. Is there some trick to getting the interconnect ports to show some activity or is there something simple I'm missing?
Keep in my I have not ran the cluster wizards etup yet, so of coure no LIF has been configured.
All of the ports aon the interconnect are configured the exact same (as they are for our working cluster) and there is no difference.
Any thoughts/suggestions etc????
::> network port show
Node: localhost
Speed(Mbps) Health
Port IPspace Broadcast Domain Link MTU Admin/Oper Status
--------- ------------ ---------------- ---- ---- ----------- --------
e0M Default - up 1500 auto/1000 -
e0a Cluster - up 9000 auto/10000 -
e0b Cluster - up 9000 auto/10000 -
e0c Default - up 1500 1000/1000 -
e0d Default - down 1500 1000/- -
e0e Default - down 1500 1000/- -
e0f Default - down 1500 auto/- -
e1a Default - down 1500 1000/- -
e1e Default - down 1500 1000/- -
e2a Default - down 1500 auto/- -
e2b Default - down 1500 auto/- -
11 entries were displayed.
::>
::>
::>
::>
::> network port show
Node: localhost
Speed(Mbps) Health
Port IPspace Broadcast Domain Link MTU Admin/Oper Status
--------- ------------ ---------------- ---- ---- ----------- --------
e0M Default - up 1500 auto/1000 -
e0a Cluster - up 9000 auto/10000 -
e0b Cluster - up 9000 auto/10000 -
e0c Default - up 1500 1000/1000 -
e0d Default - down 1500 1000/- -
e0e Default - down 1500 auto/- -
e0f Default - down 1500 auto/- -
e1a Default - down 1500 1000/- -
e1e Default - down 1500 1000/- -
e2a Default - down 1500 1000/- -
e2b Default - down 1500 auto/- -
11 entries were displayed.