Hi, I have a single chassis dual controller FAS8060 that I am trying to create a brand new cluster with. I've done this plenty of times and this is something I've never seen. Whenever the the creation process starts I get the following error..
Trying to create cluster again as previous attempt failed. Error: Unused cluster ports exist in the cluster. One or more ports may not be in the "healthy" state, or may be incorrectly assigned to the "Cluster" Ipspace. Run "network port show -ipspace Cluster" to view the cluster ports. Correct any issues, and then try the command again.
I've been researching this and have tried everything that could possibly be the issue and it has either been setup the correct way already or I have corrected the issue. All the ports seem to be fine except that all the ports are "blank" where it should say healthy or degraded. Also, this was previously a a dual chassis unit that has been requested to consolidate into a single chassis unit. I did already confirm that the psm-cc-config? variable is set to true and the the ha-config on both nodes in maintenance mode is set to HA. Also just to add this is a switchless unit, which I was able to set in both nodes in the advanced priv. Anyone ever seen this problem before? I can't find anything like it anywhere in my searching other than the couple of things I listed. Sorry for the long post but this is driving me crazy especially because I know it's probably something simple I'm missing.
Thanks
