We just installed a x1143a cna adapter with the assistance of a contracter, and the links aren't coming up . I'll add some information below, as we are unsure where the issue is currently.
running system controller config show-errors -verbose shows
sysconfig: slot 1 OK: X2069: PMC PM8072; PCI-E quad-port SAS (PM8072)
sysconfig: slot 2 OK: X1143A: QLogic ISP 8324; Dual-Port 16Gb FC/10GbE PCIe CNA
sysconfig: No shelf configuration errors detected.
sysconfig: There are no configuration errors.
Configuration Info and Errors for Node:
running system hardware unified-connect show shows
Current Current Pending Pending Admin
Node Adapter Mode Type Mode Type Status
------------ ------- ------- --------- ------- --------- -----------
san-nap01-03 2a cna target - - online
san-nap01-03 2b cna target - - online
and running network fcp adapter show -node san-nap01-03 -instance
Node: san-nap01-03
Adapter: 2a
Description: Fibre Channel Target Adapter 2a (QLogic CNA 8324 (8362), rev. 2, CNA_10G)
Physical Protocol: ethernet
Maximum Speed: 10
Administrative Status: up
Operational Status: link not connected
Extended Status: ADAPTER UP
Host Port Address: 0
Firmware Revision: 8.7.0
Data Link Rate (Gbit): 0
Fabric Established: false
Fabric Name: -
Connection Established: loop
Is Connection Established: false
Mediatype: ptp
Configured Speed: auto
Data Protocols Supported: fcp
Adapter WWNN: 50:0a:09:80:80:81:ed:70
Adapter WWPN: 50:0a:09:81:80:81:ed:70
Switch Port: :
Form Factor Of Transceiver: SFP
Vendor Name Of Transceiver: FINISAR CORP.
Part Number Of Transceiver: FTLX8574D3BCL-QL
Revision Of Transceiver: A
Serial Number Of Transceiver: AZK0AHV
FC Capabilities Of Transceiver: 10 (Gbit/sec)
Vendor OUI Of Transceiver: 00:90:65
Wavelength In Nanometers: 850
Date Code Of Transceiver: 18:05:08
Validity Of Transceiver: true
Connector Used: LC
Encoding Used: 64B66B
Is Internally Calibrated: true
Received Optical Power: 0.0 (uWatts)
Is Received Power In Range: false
SFP Transmitted Optical Power: 0.0 (uWatts)
Is Xmit Power In Range: false