Hello,
I have some troubles with one of our NetApp clusters, which was not configured by us. I have to update them and I saw a very confusing configuration of the BroadCast domains.
Bobby::> network port broadcast-domain show
IPspace Broadcast Update
Name Domain Name MTU Port List Status Details
------- ----------- ------ ----------------------------- --------------
...
ubimet ubimet 9000
Pesto:a0a-9 complete
Pesto:a0a-10 complete
Pesto:a0a-8 complete
Pesto:a0a-11 complete
Pesto:a0a-12 complete
Pesto:a0a-7 complete
Pesto:a0a-6 complete
Pesto:a0a-13 complete
Pesto:a0a-14 complete
Pesto:a0a-24 complete
Pesto:a0a-22 complete
Pesto:a0a-23 complete
Squit:a0a-6 complete
Squit:a0a-7 complete
Squit:a0a-9 complete
Squit:a0a-8 complete
Squit:a0a-11 complete
Squit:a0a-10 complete
Squit:a0a-12 complete
Squit:a0a-13 complete
Squit:a0a-14 complete
Squit:a0a-22 complete
Squit:a0a-23 complete
Squit:a0a-24 complete
...As you can see, there are completely different VLANs in the same broadcast domain. Does this really work in a case of a failover, so that the partner node uses the right port?
Normally, I configure broadcast domains like this:
Bobby::> network port broadcast-domain show
IPspace Broadcast Update
Name Domain Name MTU Port List Status Details
------- ----------- ------ ----------------------------- --------------
...
ubimet 172.18.20.0/23
1500
Squit:a0a-80 complete
Pesto:a0a-80 complete
...Here, each broadcast domain has only one VLAN configured with one port on each partner. This is working when a node is failovered.
Would be very nice, if someone can give me here a statement, if the above config is failover compatible.
Best regards
Florian